No. 11545 minCar

How to change a flat tire

Published September 28, 2026.
The short answer

If the car is on level ground away from traffic, you can change a flat: hazards and parking brake on, a chock behind the opposite wheel, loosen the nuts a half turn while the tire touches the ground, jack at the marked lift point, swap the wheel, and tighten the nuts in a star pattern. Practice once at home first.

You come out after a late shift to a flat on a quiet side street.

About 45 minutes to learn. Shared essential. Know your limits: the stop and call box is part of the skill.

Why it matters: It is the most cited skill on every list, and one practice run makes it doable.

Stop and call a professional if

  • you are on a highway shoulder, a bend, a bridge or a slope: stay belted in the car or behind a barrier and call roadside assistance
  • a lug nut will not move, needs a locking key you do not have, or the spare is also flat
  • the car feels unstable on the jack at any point: lower it and call for help

Steps

  1. Stop on level, firm ground away from traffic; if you cannot, stay in the car and call roadside help.
  2. Turn on the hazards, set the parking brake, put the car in park, and block the wheel diagonally opposite.
  3. Find the spare, the jack and the wrench, and check the owner's manual for the lift points.
  4. Loosen each lug nut a half turn counterclockwise while the tire is still on the ground.
  5. Place the jack at the marked lift point and raise the car until the flat just clears the ground.
  6. Remove the nuts, pull the wheel off, fit the spare, and thread the nuts on by hand.
  7. Snug the nuts in a star pattern, lower the car, then tighten them fully in the same pattern.
  8. Check the spare's pressure and speed limit on its label, and get the flat repaired soon.
Tire change sequence and the star patternA wheel with five lug nuts numbered in a star pattern: top first, then lower right, upper left, upper right and lower left, so each nut is across from the last. Beside it, the three stages: loosen the nuts a half turn while the tire is on the ground, raise the car with the jack at the marked lift point, then after fitting the spare tighten the nuts in the star order and again once the car is back down.142531. Loosen on the grounda half turn each, before jacking2. Jack at the lift marklevel ground, parking brake on3. Tighten in a starthen again with the car down
Loosen the nuts on the ground, jack at the marked point, then tighten in a star pattern.

Questions to ask the professional

  • Can this tire be repaired, or does it need replacing?
  • Should the other tires be checked while it is here?

Common mistakes

  • Jacking on a slope, gravel or soft ground.
  • Putting any part of your body under the car while it is on the jack.
  • Driving on a small temporary spare faster or farther than its label allows.

Self-check quiz

3 questions. Your score is saved only in this browser.

1. Which wheel do you block before jacking?
2. What does the label on a small temporary spare tell you?
3. You got a flat on a busy highway shoulder. What is safest?

Teach this to someone

A one page sheet for showing a friend, a teenager or a parent: what to say, what to show, and one question to check it landed.

Your checklist

Saved only in this browser.

Words on this page

Written in our own words. It is general information, not advice for your situation; where a professional, your doctor or your lease says something different, follow them.

Published .