No. 08630 minHome fixes

How to use a drill for beginners

Published September 28, 2026.
The short answer

To use a cordless drill for the first time, charge the battery, fit the bit by tightening the chuck by hand, check the direction switch is set to forward, and choose a low clutch number for driving screws or the drill setting for holes. Hold it straight, start slowly, and let the drill do the work. In a rental, check your lease before drilling walls.

About 30 minutes to learn. Take care: read the stop and call box before you start.

Why it matters: It is on every list, and it turns a dozen hanging jobs from impossible to easy.

Steps

  1. Charge the battery fully and put on safety glasses.
  2. Open the chuck by twisting it, insert the bit, and twist it tight by hand.
  3. Set the direction switch to forward; reverse is for backing screws out.
  4. For screws, pick a low number on the clutch ring and raise it if screws stop short.
  5. For holes, turn the ring to the drill symbol and choose a bit: wood, masonry or a multipurpose bit for drywall.
  6. Mark the spot with a pencil, check the wall with a stud finder that detects wires, and avoid areas directly above and below outlets and switches.
  7. Hold the drill square to the wall, start slowly, then increase speed with steady pressure.
  8. Pull the bit out while it is still turning to clear the dust.
Three ways to fix something to a wallA cut-away of a drywall wall. On the left, a long wood screw passes through the drywall into a wooden stud: the strongest fixing, for heavy mirrors and shelves. In the middle, a toggle bolt passes through the drywall where there is no stud, and its metal wings open flat behind the board to spread the load. On the right, a small plastic plug sits in the drywall with a short screw: for light items such as a small frame only.studScrew into a studheaviest loadsToggle bolthollow wall, medium to heavyPlastic pluglight items onlydrywall
Pick the fixing first, then the bit: a pilot hole for a stud screw, the anchor's own size for a toggle or a plug.

Stop and call a professional if

  • you need to drill near outlets, switches or light fixtures, or a scanner shows wiring
  • you hit metal or water appears: stop, close the water valve if needed, and call the landlord or a professional

Common mistakes

  • Driving screws on the drill setting, which sinks them too deep or strips them.
  • Leaving the switch in reverse and wondering why nothing happens.
  • Drilling a rental wall without checking the lease.

Self-check quiz

3 questions. Your score is saved only in this browser.

1. What does the reverse switch do?
2. Which setting suits driving screws?
3. Before drilling into a rental wall, what should you check?

Teach this to someone

A one page sheet for showing a friend, a teenager or a parent: what to say, what to show, and one question to check it landed.

Your checklist

Saved only in this browser.

Words on this page

Written in our own words. It is general information, not advice for your situation; where a professional, your doctor or your lease says something different, follow them.

Published .